Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello sir, i am facing a problem in programming atmega 2560. i used extreme burner 1.3 to set the fuse bytes. when i read the fuse byte initially lfuse was 62and hfuse was 99.. after that i wrote lfuse as F4 and hfuse as D9.. aftr writing the fuse bits i am unable to read or write the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
