Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Try subtracting the two objects and make sure to select "Clone tool object" before you do so or else you will lose part of the geometry.
HFSS does not like intersecting objects, even if the intersecting region is only 0.00000000001 m thick
Hope this helps.
Best Regards,
Vittal
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.