Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Figured it out!
Purely syntax. All buses and ports with buses passing through them use brackets [] not parenthesis (); i.e. busname[1..9]. I knew this too, as I had one bus that was fine, I just didn't notice that I messed it up on the bus that I pass from sheet to sheet! I think I messed it...
I have the same problem as Nolan. I have a top sheet with two sub sheets that are linked with a bus. However, I end up with an error about duplicate net names and it will reference one net in each sheet.
If I remove one of the sheets and put its circuit in the TopSheet, everything works fine...
While that would probably work OK for my CurrentSensors, it will pretty much eliminate the usefulness of the repeat command when I move to my digital IOs which will all go through a buffer chip with 14 channels.
There has to be a way to accomplish what I am trying to do, use one schematic...
That will only change which part will be used. So if I select 1, every 'channel' uses part 1 of the component. Select 2 and every 'channel' uses part 2. I never get different channels using the same component.
Thanks,
Jim
- - - Updated - - -
Please excuse the incompleteness of the design...
Hi,
I am trying to learn Altium Designer, but I have kind of hit a wall.
I have 9 identical circuits that I have defined using a sheet symbol with the Repeat(sheetname,1,9). Seems to work great, except I have a component that has 2 identical parts (A dual gain Amplifier, LM6172). Each...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.