Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello everyone,
I am having problems with my half-bridge driver circuit. I am using the linear technology LT1160 (https://www.linear.com/pc/downloadDocument.do?navId=H0,C1,C1003,C1142,C1114,P1133,D1303) to drive two IXYS IXFN170N10 mosfets (**broken link removed**). My problem is...
IanP,
Just wanted to let you know I built the circuit like you recommended (using 555 timers) and it works great! I actually cascaded three of them and I am able to generate variable duty cycle and frequency pulses for high and low side mosfet drivers, and I can also vary the phasing between...
Thank you very much for the reply and the circuit! Can this circuit be pulse-width adjusted? What about PWM chips, do you know anything about these? Thanks!
555 dead time half-bridge
Hello,
I am using an LT1160 half-bridge driver from Linear Technology to drive a couple of MOSFETS in a power supply I am working on. Right now I have the setup working properly on the bench; I am using a pulse generator with a built in digital delay as the PWM input...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
