Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Solution of the "Analysis and Design of Analog IC&a
First, thanks you very very much!
I have searched the solution of that book for a long time.
Can you post chapter1 to chapter5 first
If possible, send to bbqsky@21cn.com
Thanks and best regards!!!
analysis and design of analog gray solution
I am studying the book "Analysis and Design of Analog IC" by Gray & Meyer
Who can provide the solution of the book?
Thanks for your help!!
Who has designed a current mode DC/DC convertor which can work at DCM mode when light load condition and CCM mode at heavy load condition (for portable device application which required to have a standby mode)
Thanks for share your experience
The DC/DC is used for mobilephone and it is implemented in a single chip
It converts the 3.6v battery voltage to 1.8v
The nomal operation load current is range from 50~200mA, when it comes to the standby mode, the load current required to output is only 100uA
I am designing a current mode...
I want to know which technic of current sense is most suitable for the current mode DC/DC converter. This DC/DC is used for portable application and require to have standby mode!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.