Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
if I understand good, He latch the uC, when U can't get to fuses and uC doesn't respond U can bring it alive by connect to XTAL1 signal gen. for e.g. made on NE555 then uC should respond, and U can change fuse bits.
Internal --> CKSEL0 = 1, CKSEL(1..3) = 0, SUT0 = 0, SUT1 = 1
external --> CKSEL0...
ks0108b
Hi, here r many posts about gLCD and KS0108B, but I didn't found many about 192x64 gLCD. I'm trying to writte somenthing on that gLCD using ATmega32 in asm. I'have never use any gLCD and I feel litle confused. I wrote a short programm and i think I can't controle it:/. Could You tell...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
