Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Im using 17.2 and I'm not 100% sure its compatible with this version I'm just assuming it is, i got it from TI's website page for the chip.
BUT, someone suggested driving nSLEEP with a rising edge since the current chopping mode is latched on an edge. So the model is waking up after 1ms which...
its just 24v, the motor voltage Vm. Maybe my model is messed up or i didnt configure right? if the parameters seem correct i should be getting some change in signal i believe?
long story short: making pwm motor driver circuit for as apart of my senior design project, trying to get TI's DRV8874 transient model to simulate inside of orcad. I believe I followed all of the info in the data sheet and it's not reacting to anything. Also, im fairly sure i imported the model...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
