Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I use Automatic gated CTS, and it is recommended by my foundry to set maxsinktran and maxbuftran to 2ns. Also I've found that the required maxtran is 4ns by my library.
After running CTS, there are some max tran violations in the CTS report for some of my clocks. like below:
Max. Rise...
Hi everybody,
When I check the design in RTL compiler 10.1 after synthesis, I get the following summary for my design.
I know that Assigns are not good and should be removed before importing design in SoC encounter and I know how to do it.
But my question is about the Constant hierarchical...
Thanks Morris for your reply.
Yes, exactly. I have half a cycle set-up time
As far as I understood by reading the Encounter RTL compiler user manuals, setting the input delay is critical when we need to capture the data at the input at same clock edge which it was launched, so extra delay is...
Dear all,
I have a question about setting input and output delays in RTL compiler.
I know the definition of input and output delays and why it is necessary to set them in order to be able to interface with external devices.
However my question is this:
I know that in my front-end the...
Thanks FvM,
The reason I said signed number, is that as long as I know we leverage the 2's complement wrap around in integrator sections to avoid overflow problem. I don't know how can we do it with unsigned number.
Also if we do not convert 0 to -1, there will be no subtraction in integrator...
Dear all,
I want to design a CIC decimation filter for a 3rd-order sigma-delta modulator with single-bit quantization.*As we know, CIC filter need's 2's complement arithmetic. Let's assume I need 16 bits internal word length for correct operation.
Now my question is, do I need to convert my...
Dear all,
I want to design a CIC decimation filter for a 3rd-order sigma-delta modulator with single-bit quantization.
As we know, CIC filter need's 2's complement arithmetic. Let's assume I need 16 bits internal word length for correct operation.
Now my question is, do I need to convert my...
Hi guys,
I have designed a 2 stage op-amp, diff input and single output. I use Cadence spectre simulation tool. All the specs are pretty good. Now I want to calculate the open loop input referred noise of OTA. But I have a question in noise simulation and I dont know if the results I get are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.