Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Tomorrow I will do just that: replace it with 4.7nF tubular ceramic capacitor and see what happens. If it works I'll post it here.
Thanks Again,
Banjojoe
I don't know why everyone thinks I'm talking about the connector. This was never about the connector. Some people thought I was talking about the connector, but all I was trying to do was to point out the part in question by saying it was near that Lemo connector. (Whew)
But now that you do...
I want to thank everyone for trying to help me. Just in case you can't tell, I'm at my wits end on this.
I'm pretty sure that this yellow component is at the input of the device, because a microphone connects to the right of it in the connector that previous post said was a Lemo connector. A...
Yes, when I put an ohm meter on it it reads as thought it is open. In other words, I get a zero reading.
Banjojoe
Added after 4 minutes:
It is in a piece of test equipment called a Gradoscop GD47 a watch analyzer made by Portescap. When I test it in or out of the board I get a zero...
Thanks Guys for posting, but i think you thought I was talking about the connector and not the resistor. So I edited my post and placed a circle around the part in question. Is it a resistor? If it is what is the value, tolerence, etc.? No one that I show this part to can say for sure. I...
I have been to several suppliers around town and the most anyone can tell me is that it is a resistor. But the value etc. no one knows. The part in question is the yellow resistor Inside of the circle. Not the connector.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.