Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
GPRS WaveCm Q24 Plus
Hi
I am using Wavecom Q24 Plus modem for GPRS connection. But i am not able to open TCP connection. The commands i am firing are listed in attached file.
Can anyone help???
Regards
BSB
memcmp c30 problem
Hi
I am using C30 tool chain (licensed), "memcmp" function is not working. I have include every possible path, but it still does not work.
any has solution to this problem????
Regards
BSB
icd2 10-00319
check the configuration bits.
BOR detect should be disable, watch dog should be off.
OR
Check the grounding between ur PC and ur controller board.
OR
Check the crystal ....
my system was double boot. one was XP and other Linux.
then i formated XP and re-installed it , but i lost grub.
Now i can recover my grub with out formatting the linux partition????
Re: How to measure very low frequencies with Pic microcontro
hi,
you can use external interrupt input for firing the event.
And do the time related task in time.
use 2 or 3 registers in buffer fashion to count time.
bye
hi,
you can use half wave precision amp, feed its o/p to low pass filter
and finaly you get a constant dc voltage, which can be easily be measured.
bye
As SPI is basically four wire system
1. MISO(master in slave out) 2. MOSI (Master out slave in) 3. CLK 4. Chip Select
for interfacing multiple devices on a single master multiple slave u need to select devices using chip select as per ur requirement.
u can also do using changing baud rate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.