Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I agree on BradtheRad comment and would suggest you use a simple PWM or even using a simple power transistor whit an RC constant has you will be able to use smaller component for the result you are looking for. Cheer!
For a clean one shot you can use a resistor with capacitor connect to either switch relay etc depending the source of the pulse if you have more detail on what you need please do so. Thanks!
Can't really remember what's the main difference between the avalanche and non avalanche mosfet but thechnically when speaking of stepper motor if you short coil it will be harder to turn so putting diode will do the same thing at high speed. most stepper motor driver are protected for that I'm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
