Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks Radthebrad
To be honest I just come back from the pub (grey cells went missing) As soon as I clicked post I knew how dumb I was:)
I`ll put it to the test later and let you know how it went.
cheers
Thanks guys
the tranny for the HDMI switch is external, input is 12v 5A so I can tap of that. Bradtherad I think you got It, correct me if I`m wrong remove the diode from your circuit solder directly from the input? Chuckey can you eleborate with a sketch given that I can tap into the regulated...
Hi All
Hope one of you clever people can help. I have a HDMI switch in the loft connected to a UPS, every time there is a long power cut and the UPS cuts out the unit does not switch back on, unless I go up in the loft and push the momentary switch(what a pain). Opening the unit shows a tactile...
Hi
I was hoping you clever guys can help me out with the values of a few components for the ICD2 clone posted in these forums a while back. The component are D5 D6 and R26 0.47 hope someone can help.
cheers
Hi All
Can you please help me with the pcb below its a adapter to connect to a willem programmers icsp connector. the connector on the right will have jump leads connected which will in turn connect to the relavent pin on ziff socket. The question is I think it need some components i.e. caps...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.