Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I just had the same problem (target device ID does not match the expected device ID). I was using the dspic33F. I had not added a 10uF capacitor between Vcap and ground although it said to in the datasheet. Once I did that everything worked fine.
Good luck!
Aaron
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
