Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I solved it but will leave this here for others. You must make a "design dataset" and not a "project dataset". To make a design dataset right click the design in the "project manager" window (left hand side where solution setup, results, etc. is) and select design datasets.
I am trying to use a data set for an impedance boundary. It gives me an error "$DataSetName is not a defined dataset name in this context". I have used the same data set to make a frequency dependent material just to check that the data set is fine and I received no error.
I have tried looking...
Hello,
I am simulating a planar antenna on a substrate that does not have a ground plane. I am changing the value of the permittivity and loss tangent. When using the optimetrics option the values of s11 gradually change as I change the material properties of the substrate. When I directly...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
