Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Help reset UPS Masterguard
I had a bad cable. The cable must be connected like this :
Battery age resets in another program than PPset. It's Reset_batt.exe
Program with instructions are in attachment.
Good luck.
Re: Help reset UPS Masterguard
It's strange... I have fresh installation wxp pro sp3, with no PowerChute-like software, straight serial cable D-Sub 9 pin fully connected...
I'll try another serial device, probably a APC Smart-UPS and I'll see...
Re: Help reset UPS Masterguard
I tried connect notebook with UPS MasterGuard A2000-19 over straight serial cable, but the software PPset reported "no conection".
The serial cable is not original (not supplied with UPS). It has pin1->pin1, 2->2, etc...
I think I have wrong cable. Can someone...
Re: Help reset UPS Masterguard
Hello
I replaced the batteries in the UPS MasterGuard A2000-19 but it is in bypass mode and the battery indicator blinking. I need advice how to reset battery age with PPset.
I contacted Chloride support at **broken link removed** but they replied that i need...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.