Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, I am trying to create a custom footprint in proteus aries for a switch but require a square pin cutout as opposed to a circular pin cutout. The footprint pad also needs to be square but this is not the issue. Thanks
The LED's are pure white but as they are a ready made it wont be possible change there configuration. In the future I will request the resistors be removed from each series string and then I will run the strip off a constant current source buck converter to improve the efficiency.
Efficiency is...
Hey, yes unfortunately my square wave signal generator is built around a 555 timer and tends to vary the duty cycle as the frequency changes, but this being a problem I will resolve another time, my idea is to ideally have a 50% duty cycle or less.
The LED strip is simply a flat flexible strip...
Hello, my knowledge is a little bit rusty but do you have a specific circuit you will place the coil in? as resonant frequency will be dependent on other components in the circuit and the easiest way to determine the resonant frequency is using a sine wave signal generator and an oscilloscope.
Hello, I have been trying to improve my battery life on a project that flashes 12V led strip. My idea was to turn the strip on and off rapidly >50hz so the flashing would not be noticeable but I could effectively halve my current consumption leading to greater battery life.
My circuit is run...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
