Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
To run 74HC595 you must have at least 3 wires that includes serial data input,latch and shift.Unfortunately 74HC595 doesnt run properly with two wires.My advise that;dont forget to add third wire(serial data input) good luck;-)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
