Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I've seen this question posted in several dead threads, but never with a solution.
I keep getting the following error when I try and run LVS on my layout.
I think the one time I've gotten it before I was able to work around by solving all the LVS errors by eye as opposed to even looking at...
Ugh, cadence is such an awfully made software. (I've gone with a workaround by simply ignoring the padframe on the schematic level and then it passes LVS) On which level of the design would the pin layers make a difference. I've double checked them, but I don't see any that don't match what...
I have a padframe layout with my basic padframe, pins and a ring for VDD and GND. I am having issues passing LVS.
This is the only LVS issue I have left and all the pads are labeled with pins. I'm hoping to finish up my first run so I can start to refine my layout. Any advice would be much...
You'll often end up with situations where there is too much power on the grid and it can actually have to be dissipated as waste. This is because the startup cost and time for a powerplant are a lot more than the running energy to put out the minimum amount of energy. This can lead to weird...
I was trying to solve an LVS error when suddenly I started getting this warning coming up whenever I run LVS.
It doesn't seem to come up when I run LVS with other layouts; however, I can't seem to get rid of it.
When RVE opens a warning pops up.
The warning says: Database cannot be opened
XDB...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
