Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Fabrication of ATF-54143 problem
Sir,
I designed class-E power amplifier with device atf-54143, in simulation it showed a gain of 14 dB but when it come in to case of fabricated design it showing negative gain of -30dB where is the problem but s11 showing -10dB but no gain at all?
Sir ,
I designed class E power amplifier with the device ATF-54143 and fabricated it. The co-simulation and circuit simulations are far different.I fabicated circuit according to Co simulation results.But after fabrication results are not matching and the drain voltage when one terminal is...
sir,
i have sended mail to avago technologies but there no reply,and i have another question in this model package SOT-343 is used and the transmission line are designed for the 1GHz inside package,but i am working on 2.3 GHz wheather i have to change the transmissions inside package for 2.3GHz...
sir ,
I am working on ATF 54143 device for class-E power amplifier design,but i am facing problem with the device model.First i downloaded ADS model of ATF-54143 from avago technologies website and did simulations but later i found Latest ATF-54143 model in ADS software RF board Flow example.Now...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.