Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I will check the datasheet of Wiznet chips mentioned.
So unlike ENC28J60, I don't have to implement any TCP/IP stack on the controller and a simple ARM controller with 32k PROGRAM memory would be more than sufficient if the Wiznet module is used, for this application that is?
Hi,
I have the following application. There would be a few DI and DO and the status need to be sent to a PC from the controller board, through TCP/IP [Modbus TCP/IP]. It is quite a simple requirement.
I had the following PIC-OLIMEX development board around which uses the PIC18F67J60 ...
I have been coding in Assembly for a couple of months now. I started with 8051 and I am now using a Microcontroller (Nuvoton) which is an 8051 derivative.
For debug purposes, I want to view the SFR values at runtime. I have 4 seven segment for my application. I can view the 256 bytes of RAM...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
