Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys, I just tried to make a 15-0-15 for dual supply for 741. The simulation in Proteus was successful. i tried it in hardware and had the problem of my 7815 getting burnt out. I cant get the reason why it happened.
All the other voltage regulators are workin gud . i used a 230/24-0-24 - 2A...
I am using a seperate 7805 for reset. i am using 317 so that i can connect other components when needed. when connect more number of components i noticed voltage drops from 5 V so i used 317 to compensate for the drop.
---------- Post added at 19:14 ---------- Previous post was at 19:13...
keil for c51, microchip MP lab for PIC and mikroC pro for PIC
**broken link removed**
mikroElektronika - mikroC PRO for PIC - C compiler for Microchip PIC microcontroller development
Keil Embedded Development Tools for ARM, Cortex-M, Cortex-R4, 8051, C166, and 251 processor families.
I tried making my own pic 16f877A development board and its not working. I measured the voltage levels and they were optimum.
Vdd=4.5V
Vreset = 4.3V(Brown out reset was disabled)
i am using an hs oscillator. to test the board i wrote a simple blinking program .
I used HS oscillator 20Mhz for...
I just figured out how to make the motor run....i introduced a buffer wic initially gives tow positions of rotor to porte and then it continue to forward the input hall sensor code to the PORTE. Now the tink=g is can u tell me how to remove that warning message about the adc?
---------- Post...
I am just analysing a asm code based on the microchips project article "BLDC motor Control made easy" also given as "00857a". i tried simulating the code using proteus with components of similar charectaristics and i am not able to get the output instead of which i am only getting the warning...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
