Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All
I would like to use the LTC3721 push pull controller from linear technologies to create the following converter:
Input of 12V output of +175V and another output of -175V, using a push pull configuration I think at the moment it is setup for 12V in and 5V if anyone could help me modify the...
Hi All
I am currently trying to simualte/design a power converter that takes in 12V and outputs +175V and -175V AC sinusoidal output (delivering a maximum power to the load of ~40W a little less than this) Can anyone suggest a good topology that I should use for this any recommendations are...
Hi all
I am looking to design a DCDC converter that takes in 12V and outputs +175V and -175V and delivers a maximum power of 300W, can anyone suggest a suitable converter topology that I should use for this?
Kind Regards
Art
Hi All
I have setup a simulation in LTSpice with components selected that I wish to create a real PCB for but wanted to simulate it first.
I am having a it of an issue with the design I used LTpowerCAD initially to workout what components to use, It takes in 12V and outputs 40V @ 7.5A. However...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
