Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
danadakk, thank you
biff44, good question. I was puzzled by it too until discovered that 2 MHz is for phase interferometry at the transceiver side, to achieve acceptable balance between maximum unambiguous range and phase to range conversion with good resolution, and 32.768kHz for time...
I need an advice on FSK receiver solution, preferably with simple binary output, similar to SE564 (Fig.11). I do not have expertise to say if SE564 may be used for such wide channel bandwidth (2MHz). Currently I have IF output from downconverter, signal of interest is a simple frequency tone...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
