Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Have you already carried out the test without connecting the load LED?
it is possible that the relay is the problem.
I always put a snubber circuit across the coil as well; either a self contained one, or a 10 Ohm resistor in series with a .22uF capacitor (for a 5VDC coil); again, for transient...
I have modified and tested the program.
I have added a TestPin.
Pin 4 (GP3 / MCLR) must be connected with 10k to + (VDD) becomes TestPin.
Normal operation TestPin open Led flicker with cadence of 1 sec.
When TestPin is connected to GND, Led will flash quickly, the delay will be practically...
ok I have been a bit sloppy, the timer is indeed only 8 bit, I wrote this code in 15 min and still needs to be adjusted but I wanted to post it to start a reaction.
ok then we make 500us instead of 1ms
I know that the Start_delay_3sec and Start_delay_5sec are not being reset, but I still had to...
I have written a program but have not tested it.
can you test this?
Greetings
albert
- - - Updated - - -
I have made some adjustments.
can you test this?
Greetings
albert
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
