Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
We have been using X’bee pro S2 module for last 5-6 years, now it’s not available, instead we have to use its replacement X’bee S2C. Our existing embedded S/W has stopped recognizing ‘End device’ which we configure using X-ctu software from PC as end device & co-ordinator which is successful...
We have developed a customize board for GSM module using SIM800 IC. When the board was tested with the sim card of Reliance company then it was not detected but when I used the sim card of Idea company then it gets detected and all the AT commands runs using the module. Why only idea company SIM...
I am working on GSM SIM900 module the previous version of PCB for GSM works and IC generate 3.3V at SIM VDD pin, but in the new version of PCB GSM IC doesn't generate 3.3V for the SIM card (at pin SIM VDD). And the AT commands doesn't work on new PCB. What could be reason for this?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.