Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I change from
CAN_InitStructure.CAN_SJW=CAN_SJW_1tq;
CAN_InitStructure.CAN_BS1=CAN_BS1_8tq;
CAN_InitStructure.CAN_BS2=CAN_BS2_7tq;
CAN_InitStructure.CAN_Prescaler=5; //72MHz/2=36MHz=PCLK1 / 5 => 7200KHz / (1+8+7) => 450KHz
to be
CAN_InitStructure.CAN_SJW=CAN_SJW_1tq...
I did it and it's work but that code is deep in register I think that code is so difficul for me. I just want to config it like this below code
void CAN_setup()
{
CAN_InitTypeDef CAN_InitStructure;
CAN_FilterInitTypeDef CAN_FilterInitStructure;
u8 TransmitMailbox = 0; // Keep...
Hi all
I try to setup for configulation CAN BUS code but it's not work I don't know why and this is ny code that's not work ( 0 error 0 waring)
help mr please :-(
Hello guy I need you to help me about How to connect ENC28j60 with STM32 by SPI module in STM32F100RB. I use Keil4 programming and I need a simple program for leaning
Thank you :-)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
