Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
So, from your statement, there may be a delay from the libraries that are currently not yet being used? For the circuitry, I have only connected the MLX90614 with the Nodemcu via the Nodemcu Base. As far as the coding, I have only uploaded the ones that I have shown previously.
As far as I've done all the wirings have been done according to the tutorial. I apologize, I am relatively new to the IoT project and not sure what you mean by pullups. I provided the image of my circuit, but for better description refer the table provided. Thank you.
1. Supposedly I wanted to measure the temperature of a human body, but so far the temperature does not change.
2. I think the problem is figuring out if there is a problem either for the coding or my sensor.
3. Apologies', below is the coding that I made but still a work in progress :
// List...
Hello I am constructing iot project using MLX90614 and Nodemcu using the Arduino IDE. However, when coding is uploaded the output comes out the same as shown. Can anyone tell me what are the possible reasons. Thank you in advance.
Hello, im doing a project on iot enabled thermal detector system using nodemcu,, I am not familiar with the ARDUINO IDE. There was an error for compiling board Nodemcu 1.0. Below is the link to the coding and the coding itself, any help is much appreciated...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
