Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
please read the following code in MATLAB for chopper amplifier
Fs = 16*131072 ; % Modulator sampling frequency Fs = 2^17Hz
how did they get these values in the code when following values are applicable to the op-amp according to the design?
modulator frequency =16khz
amplifier...
please read the following code in MATLAB for chopper amplifier
Fs = 16*131072 ; % Modulator sampling frequency Fs = 2^17Hz
how did they get these values in the code when following values are applicable to the op-amp according to the design?
modulator frequency =16khz
amplifier...
difficulty interpreting matlab code for a chopper amplifier
please read the following code
Fs = 16*131072 ; % Modulator sampling frequency Fs = 2^17Hz
how did they get these values in the code when following values are applicable to the op-amp according to the design?
modulator frequency...
thankyou erikl.
do you know the maximum allowable length and width supported by cadence 130 nm technology for a single mosfet
the maximum length and width supported by cadence 130 nm technology
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
