Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hai friends,
i am in a experiment,my aim is find out steady state temperature without doing experiment,
consider iam passing a current of 1A to a heater wire(5 ohms), temperature of the wire should be increasing with time as per the heat generation formula
q= i2rt, but due to convective heat...
To sort out the confusions relating to my question,iam clearly mentioning my need.
I am in need of a device(other than solenoid and bimetal) which will give mechanical output when electrical supply is given...
constraints relating to it are
-it should be operable on 5v-12v dc
-it size can range...
I am thinking of having a small and simple device which will give mechanical output when a electrical supply(5v) is given.
Note:you can suggest me the technologies other than solenoid,bimetal,motor.
which will be useful in carrying out my project.
thank you guys.......................
ya thats great,
using servo motor with threaded screws serves the purpose,but installing & operating the servo motor is harder and costlier than the earlier used solenoid.
can u suggest me some ideas which is simple and low cost:-).
thats good,
but the size(~10*15mm) and power loss of the actuator is also constrianed.here i need is the mechanical force to push.can u give me more ideas
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
