Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I guess the connection in schematic is not snapped to electrical grid of component pin, just recheck it once.
I suggest you to delete old connection & redraw it.
Rgrds,
Anil
Hi,
You can try following,
View/Connections/Show all.
or
Check the PCB panel what is the option you have selected from the dropdown menu, you should select the nets.
Rgrds,
Anil
Hi,
You can change the settings in Preferences.
Go to DXP/ Preferences/ Schematic/ Mouse wheel configuration------------- for schematic
Go to DXP/ Preferences/ PCB/ Mouse wheel configuration--------------for PCB
Rgrds,
Anil
Hi,
PCB3D is a legacy library type, not used from Altium Designer 10 onwards. 3D models are now incorporated into the footprint, in the footprint library.
Rgrds,
Anil
Hi,
If you need net information after copying the design, go to Design/Netlist/Configure physical nets.
This will assign net name's as NewNet1, NewNet2......
Rgrds,
Anil
Hello All,
I have designed one development board using LPC 1768 and it is working fine.
While designing i didn't added the Ethernet interface on it but now am trying to implement Ethernet also so i have purchased one break out board for Ethernet interface which is designed using ENC28J60 and i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.