Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I read that for coplanar structures there's supposed to be ground reference planes. I simulated using both configurations, attached I'm showing results for grounded coplanar with ground reference ports and vias (red), with vias and just single ports (blue), and with no vias and ground reference...
Thank you all for your answers.
I know that for CPW there's no need for vias and just grounded ports referenced to single ports will do the job. However, I'm working with grounded CPW, so I thought about adding vias, but I don't know if I did it correctly. I defined the substrate as via in the...
Hello,
Using Matlab code I developed and AWR Tx-line calculations I got for a 50 Ohms coplanar waveguide line with ground plane
W = 51 mil ==> Line Width
G = 6 mil ==> Gap Width
I'm trying to simulate it in ADS momentum, I'm using single ports for the line, and ground reference ports for the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.