Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Alturist,
I have simulated and exported (S2P file) a microstrip reflector unit cell from Ansys HFSS. Now, I want to import this S2P file in Cadence virtuoso. Can anyone explain which steps should I need to follow to do this.
From my knowledge, I know that analogLib contains two port...
Dear Altruist,
I want to characterize a high-frequency RF switch in cadence virtuoso. But I don't know how to connect the N_BPW_33RF NMOS in cadence virtuoso to characterize the switch.
I'm really confused about the "NW" and "PSUB" node of this switch. I would be highly grateful if anyone...
Hi all,
I want to design an NMOS varactor in Cadence. where the source and drain of NMOS are shorted together like the attached figure. And the gate is controlled by another voltage. I have all the required parameters of this S/D gate NMOS varactor.
I want to know how do I plot the Cv vs Vgb...
Hi all,
I want to build a 410 GHz high-frequency microstrip patch antenna in the UMC 130nm CMOS process. For this purpose, I have already built the geometry of the patch antenna in HFSS software. But I need a high-frequency switch to control the reconfigurability of the antenna. This means I...
Hi all,
I want to assign boundary of this box (marked with blue line) using Lumped RLC. But I cannot assign the new current flow line on this box; since I want express it as a R/L/C parameters. It shows that "the new assign current flow line can be created on the selected surface". How can I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
