Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Difference between actual and expected frequency can go negative. Did not mean the actual frequency.
Thanks for pointing out the syntax error in the if command.
Thanks for your quick response.
Unfortunately I think where value and cross doesn't work as I can have cases where the output frequency-desired frequency transitions from 5k to say -3k for successive trim combination, as in that case the value command may not give me correct response when the...
I am running a trimming simulation in Cadence ADE to find the optimum trim bits for my oscillator. For the simulation I am varying the 2 trim bits during transient simulation and finding the frequency of the clock for each trim bit. What I now want to do is to find the trim bit configuration...
I am comparing a voltage reference with an input signal in a clocked comparator. I was facing issue of kickback noise of comparator affecting the voltage reference signal. To shield the reference voltage, I placed a unity gain buffer op amp with its input being set to vref and output going to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.