Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your collaboration, yes, it works fine, but my meaning is that we are not able to simulate it without a vacuum dielectric inside of a hollow waveguide.
Hi,
I am a newbie to HFSS, however, I have some experience with CST software. Today, I started to simulate a hollow rectangular waveguide. I placed two rectangular planes as ports on both sides of the waveguide but the HFSS showed me the "Port refinement, process hf3d error: Port 2 does not...
Hello,
Here is my circuit:
Regarding the transmission line theory , the input impedance of a shorted-circuit is Zin=Rin+JXin=J*Z0*tan(theta) and Rin=0. For a shorted-circuit quarter-Wavelength that theta=90, if should show the Xin=Infinity and again Rin=0. During my simulation I see the Rin...
Hello,
I need to know how I can clarify the power handling of a Rogers board. I need to build a 10Ghz power combiner for combining two-200Watt signals and I am curious to know the microstrip board's maximum power handling.
Any help will be appreciated.
Hello,
I did a parameter sweep in ADS. The output plot is shown here:
I need to show each plot's name. So I enabled the "Display label"
But as you can see all the labels are placed on each other and I am not able to change each plot label name position.
Is there any technique to change...
Hello,
here is my simple project:
I calculated the inductance value to have J50 reactance at 500Mhz. As you see the output results, S-parameters and input impedance, the real part and image part of input impedance are not correct. As you see the input impedance should have imaginary part but...
Hi,
Regarding the CST documentation, the data exported as a whole. So for this kind of solver you can not filter them with ASCIIExport. If you need to have something special you should work with I/O file functions.
Aren't the results the same? or do you have any other configurations?
Hi again,
I checked your code and your template project. it is because of your solver type and the simulation format. the code provided by you works fine if you change the solver or problem and you will see it will work.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.