Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I think before this i misunderstand already. I direct save the drill file from gerber file (camtastic) there, so the size of drill act is the total size for hole and pad. Now, i save the drill file from NC drill file there, the size is correct. So, izzit means that wehave one drill file only?
Thanks for help. I post the pcb file here... Hope can find the actual problem through it. Cause act the setting followed the instruction dy. The problem still occurred at all.
Act I dono where can change dy. There are not many step need to do in order to create the gerber file. But about the drill file, i din set any thing because dono where can do setting. Can tell me where can do the setting?
Hi, i still cannot install the GCprevue yet. So, still cannot check the drill file by myself. I can share the file, but the problem is i dono how to share it here?
Please Help me..
I used RS-274-X format. no, the tool sizes is separated from the drill data. but result still wrong. Is there have any setting during save the drill drawing. Coz yesterday Keith give me the manual for gerber file cretaed. But it din mention about the drill drawing. And is the setting for gerber...
Hi
is anyone there know why the pad size become smaller than the hole size when in gerber file? I used dxp protel 2006 to design pcb. In layout, my pad size is bigger than the hole size, but when in gerber file, the opposite situation occurred. Is there anyone can help me solve this kind of...
thanks for ur quick reply. I can generate the drill and gerber file. But i cannot open it. How to solve it if like that? Or i just attach the drill file there ka?
Hello, I am new in this forum. Hope u all can help me solve the problem occurred. Thanks first
In my laptop, the hole size is smaller than pad size for every component in layout (DXP PROTEL 2006). But when sent to the fabrication company, they say my hole size is greater than the pad size. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
