Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello...
could anyone please tell me how exactly to send at commands from 8051 to a sim300 gsm module?? Particularly using printf statements:!: i have tried sending it through strings and been successful to receive it at the serial window. But i saw a sample program on net which uses simple...
can anybody pls explain me about the alarm mode in sim300?? I read the sim300 hardware manual and such stuff but i could not understand from anywhere as to what happens when alarm is set off and which pin goes high?? Also i read if its set to silent mode it just sends a text. So what is this...
Re: geyser control with 8051
thank you both!! as bassa improved the circuit i shall first find out what our apparatus needs and understand whatevr components u have suggested of and then make a query with you thank you:D
Added after 11 minutes:
AND just one more doubt before i start off.. I...
geyser control with 8051
hello everyone..i am doing a project on water heater control using 8051. Can anyone tell me how to interface 8051 and geyser(water heater) through a contactor/relay?? My doubt here is 8051 is low voltage output and geyser is a high current device. So how should it be done??
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.