Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi
what Mr. shankar is saying, its correct.
well the current difference will also depend on which parameter you are making mismatch and obviously on gain of your Differential amplifier.
nmos tie bulk and source
you can connect bulk to different potentials as per your requirement of Vth.
As Vth depends on VBs
for + ve bulk voltage, Vth will increase. Whereas for -ve bulk voltage Vth will decrease.
define setup time
hi
The definitions that you have given are correct.
you can add these sentences too:
The Setup time is because of stray capacitance at the input.
and Holdup time is because of switching time of internal transistors and diodes.
Non idealistic on saturation region--
Means Variation of device current due to "Channel length modulation".
Ideally device current in saturation must be constant showing straight line, but because of Channel Length modulation effect current varies with Vds.
Channel length modulation is also...
electronics project in rfid
hi kazzam
If you really want to do something different with microprocessor/microcontroller, then
you can go for project like "RFID system". This is Radio Frequency Identification System.
You just search out RFID on Google you will get lots of material on it.
Well...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.