Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have 3 years of experience on embedded c on microcontroller and pcb design 4 layer board and am planning to establish a small company but the problem is i need some projects in order to run the company . I have tried freelance kind website for at least for 2 month but still am not...
HI
i am amit and i have studied diploma and worked 1.5 years in embedded domain i am looking for job where freedom must be there to work i love electronic but didnt get correct job for me so if any buddy can help me....
HI
i have got a project where a lcd monitor should be connected to p89v51rd
and what code i write should displayed at monitor so i am in the beginning
i don't know schematics and some concepts so that i can code it in c
sir your tell to store the data first and then match that data with '$' and again store it in another array..
---------- Post added at 12:14 ---------- Previous post was at 12:10 ----------
sir i want to read $GPGGA only not all ..
s i have done it
this is code now what u told
#include<reg51.h>
#include"lcd.h"
sbit inr=P3^3;
char comma_position[15];
char info[70];
char test[6]={"$GPGGA"};
unsigned int check=0;
void send_cha(unsigned char t)
{
SBUF=t;
while(TI==0);
TI=0;
}
void read_data()
{...
i will get message but not what i want..
---------- Post added at 18:23 ---------- Previous post was at 18:17 ----------
sir i have done that only but here in between ascii and int i.e from SBUF to int or char i am not able to take the data ..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.