Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In the following program:
1- How is the location marked?
2- Multiple locations can be marked?
AND
3- What is the meaning of Following Commands :
Place(x) = &H20
&
If Gps = 125 Then Goto Looploops
$regfile = "2313def.dat"
'XTAL = 3.68 MHZ
$crystal = 3686400
'By default the modem works at...
My problem Not resolved
MY PWM controller is SG3525
Feedback is working properly in no load
My problem is that How do I control sg3525 for "heavy load" and "light load"?
Thanks but The main problem is dc bus voltage drop :
dc bus voltage( no load)=333 volt & input voltage=13 volt
dc bus voltage( load=40 watt)=295 volt
dc bus voltage( load=145 watt)=277 volt
dc bus voltage( load=245 watt)=254 volt
dc bus voltage( load=345 watt)=223 volt
dc bus voltage( load=400...
Best refrence for designing of high Frequency ( ferrite core) transformers and inductors?
how Transformer and Inductor Design Handbook, Colonel Wm. T. McLyman?
I research in field of switching power supply and I don’t enough information about designing and winding of high Frequency inductor and transformer.
Therefore, I request you introducing practical references about designing and winding of high frequency inductor and transformer.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.