Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
We tested our product in RF testing Lab and got FCC certfication and FCC ID.
Are there any requirements for RF acceptance tests during production?How could I be sure that the device I've tested in external lab now doesn't not exceed FCC limits in mass production.
Thanks
The main idea is clear now, thanks you all.
Few more questions please,
Are efficiency and return loss relevant for receiving as well?
In case of omnidirectional antenna ,what is the technic to measure antenna efficiency?
Because that omnidirectional antenna transmits to all directions very...
I'm trying to calculate or simulate capacitor charge/discharge behavior while connected to constant power load (DC-DC) and at the same time charged by a battery. (Battery, capacitor and DC-DC connected in parallel)
There are two power modes, low and high. Most of the time the load is in low...
Hi Hadi,
The antenna datasheet specifies three paramaters: Impedance =50 Ohm,VSWR= 2.3:1 and return loss =-9dB
Does it mean that in perfect impedance matching to 50Ohm the antenna still have reflected power of -9dB? and no matter what it will be impossible to get vswr 1:1?
Hi,
Please hep me with following basic RF questions:
What is the different between Antenna return loss and antenna efficiency?
What does antenna return loss mean? Doesn't return loss depend on the impedance matching?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.