Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to make a voltage monitor circuit. 0V to 2.5V LED on and 2.5V to 5V LED off .When I test with Proteus this circuit works well. But practical circuit, analog input pin cannot get to zero volts. It’s always show about 2V. From 2v to 5v range works. I disconnect analog input pin and measure...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.