Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear aruipksni
Thank you for your replay
Yes I am quite sure from the code, I can read the address of the MPU6050 from 0x75.
My initialization code, is Only writing to the register 0x00 except the three registers
MPU6050_RA_PWR_MGMT_1 -- 0x02
MPU6050_RA_GYRO_CONFIG --0x0F...
Hello everyone
I am trying to access the MPU 6050 from an FPGA controller, for setting up the FPGA I have programmed the following registers only:
MPU6050_RA_PWR_MGMT_1
MPU6050_RA_GYRO_CONFIG
MPU6050_RA_SMPLRT_DIV
But I am still getting 0x00 when I try to read the Gyro output register.
My...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
