Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Scan insertion how we decide
1 compression ratio
2 compression chain
3 compression chain length
How this three Parameter affect our Test data and Test time
use of lockup latch is for resolve hold violation but doubt is that the when neg. edge flop followed by pose. edge flop both have different clock then lockup-latch is required or not ???
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.