Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Can anyone help me design a 4 port rectangular waveguide switch in CST microwave studio?There is no example given in the tutorial.I tried designing it,but the s-parameters are showing erroneous results.
The correct answer is 22 KHz;but I don't know how.The noise is bandlimited to 10-12 kHz.If we apply bandpass sampling theorem the sampling frequency will be (2*F higher/N) where N is an integer.so sampling frequency is (2*12/12/2)=24/6=4 kHz
hi,
A signal is band-limited to 0 to 12 kHz. The signal spectrum is corrupted by additive
noise which is band-limited to 10 to 12 kHz. Theoretically, the minimum rate in kilohertz
at which the noisy signal must be sampled so that the UNCORRUPTED PART of the
signal spectrum can be recovered, is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.