Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
Is is correct to use two different channel lengths in 2 stage opamp design ???
Will it cause offset ?
I am using 0.18µ CMOS tech.
I am using L = 0.54µ in stage 1 and L = 0.18µ in second stage.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
