Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i think u have a pcb document and load net-list on this and add that footprint on your doc after loading net-list.
that is fault
after loading net-list all of copper layers checked by DRC(Design Rule Check) so when you add a new footprint on pcb doc ,added footprint pads dont have any...
i draw line between pads on pcb library editor and place it on pcb sheet and dont have any error
no clearance error, no short circuit error
is this on library scope?
hi
is your purpose add a free footprint after net list loading to your board?
if this is your problem u most assign mentioned nets to mentioned pads
if you do this you can trace mentioned pads much as on your footprint pads aren't twins and they names are different.
hi
in Sch Editor on properties component you can add 3d model to component
look:
- - - Updated - - -
for create 3d model you most use 3d editor software for example:3d studio Max
when you create 3d model you can add this to Mentioned component
hi
i want know are you create new footprint with surface pads and through hole pads?
if u want have a component with 2 package, you should create new footprint in PCB Library Editor Like this
**broken link removed**
attention to pad designators(all of them should twines)
add your footprint to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
