Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In my project I want to control a mobile using AT commands. I'm trying it with my SE w200i. But I'm struggling here with finding the Rx and Tx pins of it. I found some articles say it's 10 and 11 pins as Rx and Tx pins. But some said that they are 5th and 6th. :s actually what are they? :o...
Thanks a lot sherazi. :) still have some problems. when i type UART in mikro C it says undeclared identifier. So, is there any other way of sending UART pattern signals in Mikro C?
Hello guys,
as usually i'm stucked in my project again. ;) So definitily in need of your help. :)
I'm doing a project regarding control switches through sms messaging. I found some circuit diagrams to connect AT supported mobile to the PIC 16f877a. but i have no idea how to write codes to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.