Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
sir, I am placing the device in breedboard for testing and I found out that the 4n28 can't trigger the 12 volt supply for the relay and i found out that no voltage in the relay side I am using QTC 4n28 0034K
sir rajik gud day! this project, i will defense it to my professor so i came up some possible questions that might be ask to me
1. whats the function of 4N28 in the circuit?
2. whats the use of the CONN-H2 the innner and outside part?
3. in the program, bat1PreviousVoltage =...
if battery 1 is <80% and >50% no charging happens at battery 1
if battery 2 is <80% and >50% no charging happens at battery 2
if battery 1 is <80% and >50% no charging happens at battery 1 and battery 2 is less than 50% battery 2 will be now charge until it reaches 80%, if battery 1 become...
if battery 1 below 50% and battery 2 is 80% battery 1 will be charging mode and battery 2 do nothing
if battery 1 and 2 below 50% the device will charge first the battery 1 until it reaches 80% that's the time battery 2 will be now charge
if battery 1 is 80% and battery 2 is less than 50%...
hi! good day!
I am planning to do a 2 - 12 Volts battery charger with some specific task:
1. the Micro controller be able to know the actual percent rate of the 2 battery
2. if the battery 1 reaches less than 50% the device will recharge the battery
3. if the battery 1 reaches 80%, the device...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
