Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I know this ok but you end up with one value for each vector. I need to segmentize my vector and calculate the peakvue for each segment then trend if or find the ftt for the whole segments. I think this is the method of the peakvue
Thank you for your reply. My data is a one vector data recorded from bearing and I want to apply the peakvue to it so if you can help me on the code or you have a code for the peakvue I'd appreciate it.
Hi all,
Please help me to find the matlab code for the Peakvue technique. I've been looking for it for long time but fruitless so please help me.
Thanks
Thanks for your code but I could not use it for my signal and I do not know how to apply it on different signal. In addition to that, I do not know what you mean by trigger signal
Hi every body,
I am very newbie in matlab. I want please a help in writing a code run by the matlab to make Time Synchronous Averaging for my signal.
I do not know how to write the code please help me if any has an idea
Thanks
Thanks for your code but I could not use it for my signal and I do not know how to apply it on different signal. In addition to that, I do not know what you mean by trigger signal
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.