Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello,
I want to add a stochastic noise to vsource, such as gauss noise. i note that there is a "noise file" field in properies of vsource.
(1) Could I use this "noise file" to add a stochastic noise. how to write this " noise file"
(2) Is there any other methods adding stochastic noise to a...
dear friend any one used (mtline) in cadence, because i used it to compare the results with lumped circuit (RC) and each one gave me difference results (waveform), and how could i calculate the power dissipation on this transmission line?
thanks in advance
i have a design of buffer using cadence, after generating the layout i used floorplan/Block placement/report placement statistics to have the below results. now i like to know the unit of (chip area) value and is it useful as estimated area value, in addition could we compare this value with...
I have a circuit (buffer) to drive interconnect, i calculate the noise of it but the form of the noise in (V^2/H), whats this unit meaning and could i use this value to know the probability of error?
thanks in advance
Hi, I have two voltage one of them +ve and the another is -ve, i like to switch between them, if we have input "1" the output is the +ve voltage and if input "0" the output should be the -ve voltage. i'm working in 90nm technology. i tried to use two transistor but there is amount of voltage...
dear friend any one used (tline) or (mtline) in cadence, because i used them and each on gave me difference results (waveform), and how could i calculate the power dissipation on this transmission line?
thanks in advance
Dear colleagues
I have recently known about fastcap and fasthenry, where i need to implement stripline in 90nm tech.
i need your help to get started with this software, where my job is on two stage, firstly get the parasitic of the stripline alone and secondly with coupled one. my work...
I want to design a transmission line on chip,
and i am now trying to calculate the driver output impedance, to match it with the transmission impedance.
i used two method:
the first one: used ohm's law and Vrms/Irms, where got on a huge value approx. 350M ohm.
the 2nd: set the vdd and vin to 0...
my work in ultra low power, using cadence.
I have designed transmitter with 150 mV. And now, as transmission line, i am trying to using (tline) in cadence, but how could i know the parameters of my transmission line.
my t-line is microstrip in layer 5 and 6, where i don't know the dimentions of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.